I’m not quite sure what the capabilities are as we add other departments. Apparently there has to be a master distribution point and that’s what Casper Admin points to when launching the application. Ideally we would like each department to have their own DP where they would configure their imaging configuration. I want everyone to be able to add there packages for the configurations to their own DP. This way when they launch Casper Admin they would see their own configurations. Is this possible?
Page 1 / 1
It's not possible at the moment to scope configurations, although I'd heard it was an open feature request and one that JAMF were looking at.
So how are people managing to add other sites that can manage their own dp's, packages and configs?
Trust. Fortunately, I am able to walk across campus and see whoever may be messing with a configuration. I handle most of the campus wide configurations and set up templates for the college level technicians. Then I tell them not to mess with a configuration that isn't theirs.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.