JSS 8.73, Casper Admin running on 10.6.8 Xserve. 12 Mac OS DP's, manual sync as needed, not auto.
I'm recently noticing that when I perform a DP sync with Casper Admin, it's glacially slow. 10.9.2 update didn't complete to even the first DP overnight.
However; if I log into the JSS, mount the CasperShare of a DP and do a simple drag-n-drop file copy- it completes in normally reasonable amount of time.
I was going to complain to the network guys, but I get normal throughput manually. Anyone?
When you use Casper Admin, you are adding an extra network hop to the Admin system (the files are copied from A to B via C instead of straight from A to B), and if your primary DP is not at the same location then that will slow things down quite a bit.
You want your Admin system to be as close to your backbone as possible, ideally on the same LAN as the primary DP.
yes, Casper Admin is running on a Mac right next to the JSS, both physically and logically switch-wise.
First time in 3 years I've seen this.
So when i copy a large file using Casper Admin, it copies the file to my jss (which is a linux box with a reasonably low amount of ram and diskspace) then copies it to my smb fileshare?
I am seeing very spiky upload speeds when syncing using Casper Admin and when copying files up to the Fileshare from my desktop so could this be to blame? I see speeds from max to a couple of kb then back to max every 3 or 4 seconds.
i have studied the load on the jss while doing transfers using Casper admin and I do not see an increase in disk or network activity.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.