Good morning all
I'm newish to Jamf so bare with me if this is obvious. Today I started prepping 2 new computers, one was pre-enrolled brand new out of the box and the other was an older MBA that I used a manual invite.
Most of the usual policies applied except for 3, the same 3 on both systems. When I check Inventory -> Management for the devices, they appear in the "Failed Commands" section with an "Invalid Status Code" listed as the status. I have tried removing these computer from the policy scopes, cancelling the commands and then re-adding them to the scopes. Same result.
Does anyone have any suggestions? I don't know why all of sudden these are 3 (specifically) are failing. They have worked for months, and I have not made any changes to them.
Thanks
