I have been experimenting with a policy assigned to two network
segments that are not included in our internal networks. Not
being a network guy I am not sure if these are configured
correctly but here are the network segments I configured in the
jss
Off network segment 1 -> 1.0.0.0 - 9.254.254.254
Off network segment 2 -> 11.0.0.0 - 255.255.255.255
All of our on network segments are 10.x.x.x - 10.x.x.x (too
many to enumerate here)
Both network segments are set up to use the distribution set in
our DMZ
I not only limited the policy to these network segment but also
to several departments.
The department limitation is working as expected however the
network segment limitation is not doing what I want it to do. I
only want the policy to run when the computers check in from off
our school networks.
Currently all computers (limited to the departments scope) are
running the policy without respect to where they are.
Is there anything obvious from this information that I have done
incorrectly?
Jim Ferguson
Senior Systems Analyst
Technology Services Dept.
Bryan ISD
979-209-1185