casper remote to outside computer ??

tcandela
Valued Contributor II

I am trying to use Casper Remote on an outside of the network computer to change its name. The computer recently checked in. When I select the computer -- advanced -- reset computer names , it comes up with computer not avialable.

should this work if the computer is not on the local network ?

1 ACCEPTED SOLUTION

charliwest
Contributor II

There are some feature requests for something along the lines of resolving this sort of issue https://jamfnation.jamfsoftware.com/featureRequest.html?id=471 (just one example) Its a great idea, you would need to have the remote machine start the connection though on check in

View solution in original post

9 REPLIES 9

thoule
Valued Contributor II

I would not expect it to work. Casper Remote uses SSH so it needs a no-proxy / no-NAT connection. If the users is at home behind a home router it won't work.

chad_fox
Contributor II

Is your JSS externally facing?

If not, I think the machine would need a VPN connection.

signetmac
Contributor

You could also do this by creating a policy scoped to that computer, and under the Maintenance tab, check the box that reads:

"Reset Computer Names
Change the computer name on computers to match the computer name in the JSS"

Leave the Policy inactive, go ahead and change the computer's name in its record, and activate the policy. The next time the computer checks in, it will adopt the name you've given it in JSS.

charliwest
Contributor II

There are some feature requests for something along the lines of resolving this sort of issue https://jamfnation.jamfsoftware.com/featureRequest.html?id=471 (just one example) Its a great idea, you would need to have the remote machine start the connection though on check in

tcandela
Valued Contributor II

@signetmac - I am trying your option,

tcandela
Valued Contributor II

IT WORKED @charliwest

TDManila
New Contributor III

@tcandela @charliwest how it worked?

wildfrog
Contributor II

@tdcxmanila I've done this reliably for quite some time. As @signetmac mentioned, leave it inactive until needed. My suggestions. . .
Set it to trigger on recurring checkin
Set the execution frequency to Once Per Computer

And when you need to use it, set the computer name in the policy, scope it to the machine you need to change, and make it active.
Then when the machine checks in, it should change the name.

Then watch the logs so that's once it's complete, make the policy inactive again until you have another machine you need this for.

signetmac
Contributor

Updating the link to the feature request/ my proposed solution with a working URL:

https://www.jamf.com/jamf-nation/feature-requests/471/casper-remote-over-the-internet