+5I thought I was able to do this before but can't remember where I found it
or if it was even possible.
I want to do a mass removal of any autorun data that is saved for any
machine. My searching today, I can only find the place to remove the autorun
data for a specific machine.
Thanks!
--
Alan Benedict
?
Macintosh Technician
The Integer Group
O: 515-247-2738
C: 515-770-8234
http://www.integer.com
+5Settings-->Mass Edit-->Autorun Data.
eric winkelhake
mundocomww
office 312 220 1669
cell 312 504 5155
+5Hmm, I saw that but it doesn't give the option anywhere in there to remove
the autorun data, I can only change. Even if I try and blank out all of the
fields, it still leaves a trace that won't allow Casper Imaging to run on
that computer.
--
Alan Benedict
?
Macintosh Technician
The Integer Group
O: 515-247-2738
C: 515-770-8234
http://www.integer.com
From the Settings tab >> Autorun Data under 7.1 JSS
Setup a smart group that will capture all your desktops you wish to remove the autorun data for.
When you select the Autorun Data option under Settings in the JSS, you'll be able to select the smart group for computers.
Click Next to review that list.
Click Next again and you'll see a button labeled "Delete Autorun Data for these Computers"
Click that button and then verify your decision.
That should remove all autorun data.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.