I was looking for a way to turn some of the power save features off through Casper and I was looking at the Energy saver section of Configuration Profiles. I see "put the computer to sleep after" and "put the display to sleep after", but the range is 1 minute to 3 hours. I was looking for a way to set both of those to never. Is there a way to do that?
Page 1 / 1
Uncheck Put the Computer to sleep after. and Put the display to sleep after. This will set them both to never(0). I'm not sure it locks it from being changed after the fact though.
I use these commands and I push it to all machines via a policy.
Display Sleep
sudo pmset displaysleep 0
Computer Sleep
sudo systemsetup -setcomputersleep Never
This post from a while back jives with what I thought. I am going to test a profile now
https://jamfnation.jamfsoftware.com/featureRequest.html?id=621#responseChild1615
Unchecking them does not seem to stick. The profile is installed and I can see System Sleep Timer = 0 but I can fiddle with the GUI and change the parameters to 1 minute and it goes to sleep 1 minute. After a reboot it sets to back to never but I would expect with this profile in place to not be able to modify the settings at all.
You may have to open a case with JAMF. I don't think that profile is working as expected.
post your config profile content
In Apples Profile Manager it's solved better. There is indeed a way to set it to "Never". Why does jamf do not offer this?
Reply
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.