Winclone Images and Dual Boot Imaging...

kerouak
Valued Contributor

Hi ,

When I upload my Winclone image to Casper via Casper Admin, It get's Zipped.
Is this normal?
When I run th eDual Boot config, All is good, however, the winclone image is not installed...

Help!

2 REPLIES 2

fabian_ulmrich
Contributor

Maybe you wanna check this post - it's definitely normal behaviour and it works for me without any problems f.e. with Adobe Packages created out of Adobe Packages Creator Tool.

https://jamfnation.jamfsoftware.com/discussion.html?id=10400

Cheers!

marktaylor
Contributor

Hi

I had the same issue a couple of weeks ago which cost me days of test imaging but we got it to work by doing the following:

Open Casper Admin
Drop your winclone image directly into the Packages Folder on your Casper Share instead of in Casper Admin
This will get it into the share without the zipping taking place.
Next reopen Casper Admin, open the Configuration, select the Partitions tab and you should be able to add your winclone image

I hope it works for you too.

Mark