Hello,
We would like to start utilizing the return to service app however I am unsure how to scope our deployment network.
Our network is cert. based so we have a temp network we use to get the devices online to get their configs and then we manually forget that network. I have return to service configured up to the point of getting that deployment network. What would be a scope I could use for these to have them only have the network loaded after return to service has ran?
I did find the plist key to set a time for it to forget the network, just not sure on the scope for enrollment.
Thanks in advance!
Dan
Question
Return to Service Temp Network
+3
+11Our Temp SSID has time and location based only limited to Jamf Cloud traffic for enrollment only. Run the Return to Service app and enroll in the tech office, it disconnects once it's out of the room and switch to the cert. based SSID.
The time based SSID is for the lab environment, once they're enrolled and times up, automatically switch to the main SSID.
Enter your E-mail address. We'll send you an e-mail with instructions to reset your password.