Skip to main content
Question

Adding Sites and Distribution Points


Forum|alt.badge.img+4

I’m not quite sure what the capabilities are as we add other departments. Apparently there has to be a master distribution point and that’s what Casper Admin points to when launching the application. Ideally we would like each department to have their own DP where they would configure their imaging configuration. I want everyone to be able to add there packages for the configurations to their own DP. This way when they launch Casper Admin they would see their own configurations. Is this possible?

4 replies

davidacland
Forum|alt.badge.img+18
  • Valued Contributor
  • 1811 replies
  • June 8, 2015

It's not possible at the moment to scope configurations, although I'd heard it was an open feature request and one that JAMF were looking at.


Forum|alt.badge.img+4
  • Author
  • Contributor
  • 13 replies
  • June 8, 2015

So how are people managing to add other sites that can manage their own dp's, packages and configs?


Forum|alt.badge.img+13
  • Valued Contributor
  • 186 replies
  • June 8, 2015

Trust. Fortunately, I am able to walk across campus and see whoever may be messing with a configuration. I handle most of the campus wide configurations and set up templates for the college level technicians. Then I tell them not to mess with a configuration that isn't theirs.


scottb
Forum|alt.badge.img+18
  • Valued Contributor
  • 1285 replies
  • June 8, 2015

Here is one marked as planned, and I can't wait.

Hide or Scope Configurations


Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings