Skip to main content
Solved

Failed Commands - Invalid status code


Forum|alt.badge.img+2

Good morning all

I'm newish to Jamf so bare with me if this is obvious.  Today I started prepping 2 new computers, one was pre-enrolled brand new out of the box and the other was an older MBA that I used a manual invite.

Most of the usual policies applied except for 3, the same 3 on both systems.  When I check Inventory -> Management for the devices, they appear in the "Failed Commands"  section with an "Invalid Status Code" listed as the status.  I have tried removing these computer from the policy scopes, cancelling the commands and then re-adding them to the scopes.  Same result.

 

Does anyone have any suggestions?  I don't know why all of sudden these are 3 (specifically) are failing.  They have worked for months, and I have not made any changes to them.

Thanks

 

Best answer by junjishimazaki

Have you tried running the following commands: sudo jamf manage 

If that completes, run sudo jamf recon, then once that completes, then run sudo jamf policy

View original
Did this topic help you find an answer to your question?

3 replies

junjishimazaki
Forum|alt.badge.img+10
  • New Contributor
  • 423 replies
  • Answer
  • June 23, 2022

Have you tried running the following commands: sudo jamf manage 

If that completes, run sudo jamf recon, then once that completes, then run sudo jamf policy


Forum|alt.badge.img+2
  • Author
  • New Contributor
  • 1 reply
  • June 23, 2022

Seems to have done the trick!  Thanks very much!


junjishimazaki
Forum|alt.badge.img+10

You're welcome, I'm glad that solved the problem.


Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings