Skip to main content
Question

Netinstall Image and ARD/SSH


Forum|alt.badge.img+7

I created an image following the instructions here: http://jamfsoftware.com/kb/article.php?id=236.
Everything looks good. I used the netinstall image creator, and again everything looks good. Netbooting works fine.

One strange thing – I can't remote desktop into a netbooted machine, and I can't ssh into one, either. Remote login gets turned off when I run the netinstall image creator. Remote management is still on and looks right, but it won't let me in.

This worked on one of my older netboot images. I have a few mac minis that I do a lot of imaging on, and I normally only access them remotely. Anybody have any ideas for me?

Thanks!
Mark

2 replies

bentoms
Forum|alt.badge.img+35
  • Legendary Contributor
  • 4331 replies
  • April 27, 2011

The image creator seems to strip out some needed components.

This is why I stopped using it.

You could try & install the client again & see if that works.

Regards,

Ben.


donmontalvo
Forum|alt.badge.img+36
  • Legendary Contributor
  • 4293 replies
  • April 27, 2011

We tried using NetInstall Creator but turned out to be a PITA. We've been getting along fine with NetBoot, where the NBI includes Casper Imaging application.

Are there any real benefits to going with NetInstall Creator workflow vs traditional NetBoot?

Don


Reply


Cookie policy

We use cookies to enhance and personalize your experience. If you accept you agree to our full cookie policy. Learn more about our cookies.

 
Cookie settings