Hi Folks,I'm putting this here to try to be a little helpful. We just
moved from v5 to v6 for GlobalProtect, and basically, the setup that we
had that, installed the stock pkg from paloalto and relied on a config
profile to set our default portal sto...
Hi Everyone, I'm having an issue, I know that I can always exclude
computers that are provisioned with depnotify to not run these policies
in jamf... but I would have to exclude on every policy that runs at the
networkstatechange trigger. Just wonder...
@jamf_wroblewski Let's see, I'm trying to think of all the things that
could go wrong with a config profile so I spit them all about below.I
would verify that in your config profile in the system extension
payload, the teamid is there and correct: PX...
So I had the exact same issue as @McAwesome, then when trying out the
solution I was getting the same error as @ericbenfer. I figured out a
solution so I'm going to put it here just in case someone is
looking.NOTE: before you start this, make sure yo...
@G_Zirrak I think I found my issue. We had depnotify installing an old
sophos package upon setting up the M1. I wiped it and excluded it from
the old sophos policy and just had it install the new one. It works with
no issues as of yet! Thanks,Nick