I've noticed that when I pull up
I get a giant list of invitation codes. Some of them never expire.
Unlimited I figured out
that I can use the ...
This is super weird. I'm using the vender package from their site and
can install the package the normal ways;installer, double click, etc.
But here's where it gets weird. If I create a policy to install it with
a manual trigger it works, but If I se...
It's been awhile since I've used this or needed to use this but here are
some steps. Drag/copy the Wacom package(.pkg) to your /tmp folder on
your mac. Open composer and create a new package, I don't have composer
anymore so can't remember which kind...
I though I'd jump in to this and let everyone know what I ended up
doing. I was able to get the package to install when I wrapped it into
another package. Basically I had it dump the wacom pkg into the
/private/tmp folder and had a postinstall script...
Well I'll be darned! It don't work... So I presume this is because self
service is user initiated so they'd know something is about to run. You
could use a script before and after to call the pop-up with your
I would go through the steps here
https://jamfnation.jamfsoftware.com/article.html?id=188 Make sure that
the management account is 100% since self service relies on that. Then
I'd check to see whats going in the jamf.log on the
I just tested on my system and had no problems. I created a policy with
a custom trigger(test) and scoped to all. Put the messages in and called
the policy from the command line with the custom trigger and the verbose
option.sudo jamf policy -trigger...