I am having an issue where after successfully imaging an mabook pro nontouchbar 13 inch the hard drive is not showing up correctly in disk utility and is not show up as a destination when trying to install any type of software. Instead of the hard drive showing the Macintosh HD partition that was the target of the imaging correctly it shows only the hard drive itself. The machine is bootable after imaging strangely. Targetmode imaging, normal netboot imaging result in this behavior. The only process so far that has worked correctly has been netbooting a machine with the image on an partition and then using diskutility to restore the image to a target disk moded macbook pro. Any suggestions for getting casper imaging to work correctly?
The image and the destination partition are both Mac OS X Extend (journaled). As for the requisite imaging is dead problem, unfortunately the problem I'm having is with about 50 Mac book pros that are slated for a lab that is used by a ton of college classes over the course of the coming semester. The machines are not DEP and a good bit of the software that is going on them is not in a package form as we do not have the resources in our shop to package everything currently. As we have imaged over 800 machines this summer with this very image so its perplexing that the same workflow of using casper imaging erasing the drive and then laying down the image is not working on just these specific machines. The workflow that seemed to work when no combination of casper imaging/netbooting would work was by doing a restore under the edit menu in disk utility. Here is the output of diskutil list on a freshly imaged machine that is show the HD incorrectly:
