First I had one mac with the issue - now few days later see a new mac with issue
The mac overall works fine, I can run all jamf commands, self service etc - I can see in the backend everything is fine, and machine is checking in, inventory - all fine
But when I go to system preferences, I have no "profiles" - I can open profiles through search, but it is just empty, no profiles AT ALL - and yes- jamf is still working ?!
I tried an sudo profiles renew -type enrollment - nothing happens, no error no info - nothing
Has anyone seen something similiar ? - Is is 12.5.1 monterey devices btw
When I do a check on profiles through terminal command on the computer it rapports nothing is installed - just as profiles GUI shows. And yes - it shows all profiles in the backend, just as other computers have assigned. And even there was no profiles in scope, how can the MDM profile not exist, but mac is still acting as enrolled ?!
in your jamf instance if you go to computers > configuration profiles and search one of the profiles which should be applied and check the logs can you find your machine in thee and check the status? also what are you soping them profiles too? "all computers" , "enrollment complete" or some other group? and is the machine appearing in that? try sending a blank push to the machine as well
Also confirm your push cert hasnt expired settings > global management > Push Certificates
I've been seeing similar issues, profiles are on the machine, the setup wizard shows the DEP enrollment and the local management accounts are created, but self service is missing. If I open terminal and type sudo jamf recon and I get a device signature error.
Only way I've found around it is to issue the remove MDM command from JamfPro, wait till the profiles are off the device (usually just a minute or two) and then manually re-enroll it.
I've seen this on net new out of the box machines and re-imaged machines with no real rhyme or reason.
I can confirm seeing similar behavior as OP and @jwojda. I just onboarded 220 new M1 Airs and about 40 recovered/erased/installed M1s from previous students. FWIW, It only happened once this year and once last year, again with similar numbers. It's so anomalous and infrequent that it's kinda jarring when you spot it.
Do policies work on these machines? Try creating a policy that runs "sudo jamf manage". As far as i know config profiles are installed via mdm, were as software installs like self service are done by the jamf binary. OP didnt say the binary was missing on the machines just config profiles not installing. I ve seen machines take a while to install the binary. You can normally force it by putting the device in airplane mode, and back out again (if you have vpp setup, and selfservice set to install automatically).