- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Posted on 04-27-2023 07:55 AM
I have an (non admin) end user using VMware Fusion 13.0.2 on a MacBook Pro M1 13.3.1.
I've used PPPC Utility to set up a Configuration Profile that has "Accessibility - Allow" for Fusion.
The end user still gets an error when they start Fusion to allow Accessibility. They are getting the profile and other profiles are working.
Any insights would be appreciated.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Posted on 04-27-2023 01:02 PM
Found the issue. There was a hung up management command holding everything else up. I feel bad I didn't check that first, but something to learn from.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Posted on 04-27-2023 09:34 AM
Does that require full disk access as well? i seem to remember...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Posted on 04-27-2023 10:02 AM
Same profile has "full disk access - allow" and that seems to be working.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Posted on 04-27-2023 01:02 PM
Found the issue. There was a hung up management command holding everything else up. I feel bad I didn't check that first, but something to learn from.
