I have been working with JAMF support trying to figure out if there is a
bug in 9.62 or Yosemite. I would love if other people try this to see if
their system reacts differently. Issue at hand:Create a Configuration
Profile for Passcode.--Check -- Re...
JSS is 9.6 I have been using the JAMF provided firewall script to enable
However, the script does not work for the 10.10.x computers.How do
others enable firewall?Any t...
I am trying to clean up the results that report back on my EA. I am sure
this is something simple but my eyes are getting cross-eyed trying to
get the correct syntax. I have an EA that reports back the board-id of
the systems. echo "$(ioreg -p "IODev...
At this time when a computer gets enrolled into my JSS, an Enrollment
policy starts which deploys CocaDialog onto the device and then I have a
"Set ComputerName" cocoaDialog script run that prompts for the user/tech
to enter in the computername of th...
Does anyone else experience a strange behavior with the computer names
on some of the clients? Each computer is named after the asset tag that
we put on the computer. Ex: D20141020ComputerName = D20141020HostName =
D20141020LocalHostName = D20141020 ...
@oneloveamaru and @adamcodega, I have ran into similar issues where
users cannot change their local account password. I discovered while
working with Jamf and Apple, that our issue was caused by putting a
check in the Alphanumeric requirement. Once I...
Strangely enough Machine 2 is all of the sudden is reporting correctly,
and it is now added into the smart group. I did nothing to fix the
issue, except close out of the Machine 2 computer details .est 10 times
and now it is reporting correctly. It i...
@Kaltsas @mm2270 @chriscollins In my findings on 9.62. I have 2 10.10.1
machines sitting on the same desk with FV2 enabled. In JSS on the
"FileVault 2 Partition Encryption State:" within the Disk Encryption
section:Machine 1 reports -- EncryptedMachi...